#Nand x trinity install update#

'NOTE' Coolrunner must be on phat for phat and slim for slim consoles, also set to program when programming the coolrunnerДҐ-Now you can wire the motherboard and the coolrunner and the nand wires for your nand reader/writerД¦-put mother board back in the cage before going to next step so many people short things out or get RROD from flexing mother board around or doing this on there bed or floor.Д§ Now once you have wired everything and double checked your work its time to test your soldering. and If its a jasper you need to make sure you check its 16mb, 256mb or 512mb If it is RGH2 you need to make sure that is marked in J-runner RGH2 there are different settings for RGH2 when programming the coolrunner. you can now go ahead and program the coolrunner to the type of board you have. Once turned off unplug it and carefully removing the dvd drive, fan shroud and the mother board from the cage.Д¤- After you figured out what RGH Version you have. 'NOTE' If it is a jasper you need to make sure what size it is 16mb, 256mb, 512mb,ДЈ- Power off the console.

Or making sure that it powers on and boots up normally.Дў- Check to see what dashboard it is on by going to Console Settings, System Info This will tell you what type of RGH can be done ont the console. Slim Coronas Best to check Version firstДЎ- Check to make sure the Xbox 360 has no issues such as damage to the console or Motherboard, checking to make sure no one else has tried to rgh the console.I can not say it enough please becareful when soldering. What makes it difficult : small soldering, must have good soldering skills, small points, easy to bridge or remove small components if your not careful very easy to lift traces.

#Nand x trinity install update#

For Corona boards and to update jr.programmer or nand x USB to NAND-X Update Cable/ Comm v3ДЄverage Time to Complete: 45mins to 1 1/2 hours.

DGX ( use only on dashboards 15574 to 16202 and above) This is used to get the cpu key from them Dashboard Kernals)' Slim Consoles only at this time.

Nand X or jr programmer or USB Nand Reader or LPT.

Corona Varies on parts you need qsb micro card reader so please Research for your type of Corona Motherboard.

Xbox 360 Motherboard (xenon) not good for RGH at this time (Zephyr, Falcon, Jasper SB/BB, Trinity or Corona).

Matrix Glitcher Chip (this can be used instead of cool runner).

This tutorial will teach you everything you need to RGH a xbox 360 console and the tools you will need for each type of console and what you will need for each dashboard. You must have good soldering skills and you must pay attention to everything you do. I can not say it any more clearer then to Read this carefully and ask questions if needed before you do anything. This will tell you everything there is to know about The RGH Reset Glitch Hack and what is needed For every console out there. ***NOTE: READ!! The whole post and replys.